6000L/H Turbine Oil Purifier Vacuum System PLC Control Used In Metallurgy
Application
Widely used in electric power, metallurgy, chemical and other industries of steam turbine, water turbine, gas turbine and other generator unit turbine oil of polymer ultra-clean, can seriously water, improve the quality of oil, restore its lubrication, speed, heat dissipation, cooling and other characteristics, to ensure the safe operation of the corresponding unit.
Description
TF turbine oil purifier series is developed by vacuum evaporation technology, coacervation technology, coalescing technology, separating engineering technology and refined purification technology. It can eliminate water, gas, impurities, colloid, dielectric etc. rapidly and effectively in high vacuum situation and make the waste oil reuse.
The lubrication of turbine or other equipments which has lubrication system need be replaced frequently because of vapor, water and other impurities mixed with it. Otherwise, oil deterioration would result in breakdown of machinery or affect the normal running of machinery.
TF series can effectively extend the lifetime of oil and protect turbine and other machinery which has lubrication system from damage.
Features
- TF Series uses polymer materials to coalesce and break emulsification to separate water molecules in oil.
- TF Series adopts compound negative pressure flash technology to completely remove liquid water, and can also remove 100% free water and 80% dissolved water.
- TF Series adopts differential pressure automatic backwash system to eliminate complicated manual disassembling and washing.
- TF Series uses air cooling, water cooling, medium condensation trinity of heat exchange device.
- TF Series ultrasonic oil level control with steam turbine, water turbine in line bridge unattended operation.
- TF Series can be designed according to the needs of PLC automatic control, with touch screen dynamic display, can be networked with computers for operation, to achieve high intelligence.
Edges
- Dehydration (Degas) System
- The vacuum vessel can enlarge evaporation area efficiently. The heater, being placed on the vacuum vessel, becomes an evaporator. Thus the evaporation area of vacuum vessel is three times more than that of the ordinary vacuum vessel. This innovation can dehydrate and degas effectively and efficiently.
- The optimal structure of the dehydration (degas) system enlarges the surface area of oil exposed to the vacuum system and extends the flowing distance of the oil in the vacuum system. Thus there has sufficient time to remove the moisture and gas from the oil by vaporization.
- The filtering materials with variable apertures are made of specialized glass fiber. The sizes of the filtering fiber and aperture dwindle gradually in the different filtering stages. The impurities with different particulate sizes are filtered step by step. The capability of removing particulate matters and impurities is improved greatly by this method.
- The filtering system has stable and perfect filtering fineness. The filtering fineness has several grades, including 1, 2,3,4,5,6,10 µm etc. Oil β≥1000 after filter.
- The filtering system is equipped with reverse rinse and filth device. It improves the effectiveness of filtering and extends the lifetime of filter awfully.
- The unique heater structure heats the oil uniformly.
- Oil Heater System assures less than 1.0 w/cm². During the heating process, the deterioration of the oil caused by overheating is avoided.
- The oil temperature can be adjusted between 20℃ to 80℃.The heater is controlled manually or automatically. The heater will stop automatically when the oil temperature reaches a certain degree.
- Being installed with safety protection devices, the heating system is secure and reliable. The heater will stop operation automatically when the oil volume of inlet is too low to avoid the damages of the heater.
- Electrical Apparatus controlling System
- The main components of the electrical apparatus made by Schneider, Siemens and so on ensure the safety of the controlling system.
- Having several protection systems which will avoid oil ejection, overload and over voltage etc.
- Oil-level Controlling System
- The oil-level floating ball or infrared liquid level automatic controller system are installed in the vacuum vessel to control the oil level so as to avoid the oil being suctioned into vacuum pump in the operation.
- The new innovation of eliminating froth can avoid the oil being suctioned into vacuum pump.
- The main component parts of NSH products such as vacuum pump, oil pump and electric apparatus are from SIEMENS, LEYBOLD, OMRON, SCHNEIDER, HYDAC, NSH, AMICO etc. It ensures NSH products high quality and reliability.
Structure and Appearance
- NSH products adopt ship-shape chassis-mount structure to ensure oil leakproof and protect the environment from pollution.
- The whole equipment is characterized by small size, light weight and convenient to move around.
- Various sizes and configurations (shield) available.
- Available in mobile or stationary options.
- Automatic vacuum oil purifier and anti-explosion vacuum oil purifier are both available according to customers’ needs.
● Conventional configuration is mainly carbon steel, according to customer needs, can also choose to use the tank pipe stainless steel material, beautiful and not corroded, can work for a long time. ● Main power parts, filtration equipment, electrical parts of the conventional configuration for domestic standard configuration, customers can also choose high-quality imported products to improve the performance of equipment.
Working Principle
When the oil purification machine starts, contaminated oil enters into the primary filter under the effect of pressure difference, in which large particles of particulate matters are filtered off. Therefrom the oil is heated and goes into the secondary filter, in which fine particles of matters are removed. Then the oil goes into the water separator, the free, soluble water is separated from the oil and drained to the water collector. After that, oil passes through the fine filter and fine particles of matters is removed during the process. Finally oil goes into the vacuum tank, where residual trace of water is removed and steam is condensed in the condenser or expelled out by the vacuum system. The reused oil is drained by oil pump in the end.
Guarantees & documentation
SINO-NSH Warrants the plant supplied under this specification against defects in material and workmanship under normal use and service for a period of sixteen (16) months from date of shipment or twelve (12) months after the start up of the system. SINO-NSH’s obligation under this warranty is limited to repairing or furnishing, without charge F.O.B. point of manufacture, a similar part to replace any part, which was proven to be defective within warranty period. SINO-NSH shall not in any event be held responsible for any indirect or consequential damages. The performance guarantee will be within limitations as detailed in duty & performance paragraph of this specification.
Two(2) copies of operating & maintenance manuals are supplied with each purifier. These systems are designed to operate with the utmost simplicity and is required, please contact SINO-NSH for additional charges.
Technical specifications
| Item | Unit | TF-30 | TF-50 | TF-100 | TF-150 | TF-200 |
| Flow Rate | L/H | 1800 | 3000 | 6000 | 9000 | 12000 |
| Vacuum Range | MPa | －0.06～～－0.096 |
| Working Pressure | MPa | ≤0.3 |
| Water Ratio | PPm | ≤ 100 |
| Impurity size | µm | ≤ 5 |
| Clearness | NAS(1638) | ≤ 6 |
| Temperature Range | ℃ | 40—80 |
| Demulsifying Value | Μin | ＜ 15 |
| Power Supply | V | ~50Hz 380V(or as needed) |
| Working Noise | dB | ≤ 70 | ≤ 75 |
| Heating Power | Kw | 30 | 36 | 72 | 90 | 120 |
| Total Power | Kw | 33 | 39 | 77 | 98 | 128 |
| Inlet(Outlet)Diameter | Mm | DN25 | DN32 | DN40 | DN50 | DN65 |
| Net Weight | Kg | 420 | 550 | 750 | 850 | 950 |
| Size | length | Mm | 1400 | 1550 | 1700 | 1800 | 1900 |
| width | Mm | 1050 | 1100 | 1300 | 1400 | 1500 |
| height | Mm | 1650 | 1700 | 1850 | 1950 | 2050 |
Another types of our oil purifier machines
TF series oil purifier: Turbine oil purifier system is particularly suitable for purifying turbine lubricating oil. It also applys to treat hydraulic, coolant oil and other lubrication in which contain large of water, vapor, impurities, sludge, dielectric and colloid. It can eliminate them effectively and efficiently.
LV series oil purifier: Lubrication Oil Filter System are suitable especially for purifying and restoring hydraulic oil, machine oil, coolant oil and various other lubrication oil.
GER series oil purifier: Used oil regeneration system is suitable to regenerate used internal-combustion engine oil including diesel engine oil, gasoline engine oil, and used hydraulic oil, other used lubrication oil of machinery.
GED series oil purifier: it is used to recycle all kinds of waste oil into base oil or diesel oil with high quality.
About us:►Sino-NSH Oil Purifier Manufacture Co., Ltd. is a high-tech Company Since 2004 which is engaged in researching, developing and manufacturing lubrication purification equipment. After 18 years' growing, NSH passed the approval of the ISO 9001:2015 quality system, Environmental Management System as per GB/T 24001-201 6/ISO 14001:2015, Chinese high-tech enterprises and another sorts of certifications Issued by Chinese Government, At the same time, we have obtained hundreds of patents for our advanced technology.
NSH regards technical innovation and satisfying service as its philosophy. Taking advantage of Human resources capital and absorbing domestic and foreign advanced purification technology, NSH is committed in making high quality purification equipment and become the main manufacture base of purification machine in China.
NSH Oil purification equipment series are extensively used in the fields of electric power, petroleum, natural gas, mechanical manufacture, steel, metallurgy, railway, aviation etc. which consume lubrication oil. It's the principal products covering more than 100 kinds of products in 7 series and can meet different needs of customers. For special demands of customers, we offer particular solutions. NSH products are not only able to low customers' cost and security risk effectively, but also solve the problem of which the waste oil contaminates environment.Our expertise positioned SINO-NSH as a leading manufacturer in China and also keeps long term cooperation with many famous international enterprises, such as: SIEMENS, ABB, CEGELEC, and STATE POWER PLANTS OF MANY COUNTRIES, etc. We are committed to exceeding your expectations.
►we practiced in this industry during all these years, and have rich on-site experiences too. Any on-site cases, please contact us for a solution.
►For detailed product specifications, please leave us your email or mobile no. To send you the catalog. Thank you!
Contact:
Shirley Liu
Email: sinonsh33@sino-purification.com
Tel/Whatsapp: +8617726298694
Product Tags:
|
|
6000L/H Turbine Oil Purifier Vacuum System PLC Control Used In Metallurgy Images
|
